Magnet wire, insulated, made from purchased copper in wire drawing plants · California
Mws Wire Industries
Westlake Village, CA · ~50 workers · 2 years of OSHA Injury Tracking Application data.
- A
- Excellent Safety Record
- 1.0
- Avg TCR
- 3.3
- Industry avg
- 0
- Fatalities
The verdict
Mws Wire Industries runs at 31% of its industry's injury rate - far safer than the typical Magnet wire, insulated, made from purchased copper in wire drawing plants workplace, earning a grade A.
- A
- Excellent Safety Record
- 1.0
- avg TCR · per 100 workers
- 3.3
- industry benchmark (BLS)
- 0
- recordable injuries tracked
Grade compares Mws Wire Industries's OSHA Total Case Rate of 1.0 to the Magnet wire, insulated, made from purchased copper in wire drawing plants BLS benchmark of 3.3 (31% of benchmark) across 2 years of Form 300A filings (2016–2024). <a href="/methodology">See methodology</a> for reporting-limitation caveats.
Injury rate over time
Mws Wire Industries's yearly Total Case Rate, against the 3.3 industry benchmark.
Where Mws Wire Industries falls in its industry
206 Magnet wire, insulated, made f establishmentsSafer than 84% of graded establishments in this industry, whose median TCR is 3.7.
Narrower to California alone (the establishments it most directly competes with for workers and contracts): ranked #1 safest of 4 Magnet wire, insulated, made f employers in California.
Trend analysis for Mws Wire Industries
Between 2018 and 2019, Mws Wire Industries's Total Case Rate held roughly steady from 0.0 to 2.1 recordable injuries per 100 full-time workers, a 0% change across 1 year of OSHA reporting.
The safest year on record was 2018, at a TCR of 0.0, while 2019 saw the highest rate, at 2.1, a spread of 2.1 points between the best and worst reporting years. That's a wide swing relative to the establishment's overall rate, worth checking the year-by-year table below for whether a single severe year is driving the average, rather than a sustained trend.
Summed across those 2 reporting years, Mws Wire Industries recorded 0 total injuries and illnesses, with no fatalities reported in any of those years. Readers comparing establishments should weigh the 2-year trend above alongside establishment size, since a larger workforce naturally accumulates more raw incidents even at a lower per-100-worker rate.
Verify This Employer with OSHA
The 0 injuries, 1 illnesses shown on this page for Mws Wire Industries are sourced from its own 2 years of mandatory OSHA Form 300A summaries. Cross-check the underlying establishment record directly against the federal source, name, NAICS classification, recordable case totals, and inspection history are all searchable on OSHA's Establishment-Specific Injury and Illness Data system.
Verify on OSHA Establishment SearchSource: U.S. Department of Labor, OSHA Establishment-Specific Injury and Illness Data. NAICS 331420 - Magnet wire, insulated, made from purchased copper in wire drawing plants.
DART Rate, Transparent Calculation (2019)
What is the DART rate formula?
DART (Days Away, Restricted, or Transferred) is computed by OSHA as incidents × 200,000 ÷ hours worked. The 200,000-hour denominator equals roughly 100 full-time workers, which lets establishments of very different sizes be compared directly.
1 DART incidents × 200,000 ÷ 96,531 hours worked = 2.07 DART
Methodology: 29 CFR 1904, OSHA Form 300A recordkeeping
Cross-Validating Context, Establishment vs Industry vs State
| Benchmark | TCR | Source |
|---|---|---|
| Mws Wire Industries (this establishment) | 1.03 | OSHA ITA Form 300A, 2-year avg |
| Aircraft and automotive wire or cable made from purchased copper in wire drawing plants industry avg | 3.30 | BLS IIF, NAICS 331420 |
| California state avg (all industries) | 5.64 | OSHA ITA, state-level rollup |
Industry benchmarks: Bureau of Labor Statistics, Injuries, Illnesses, and Fatalities (IIF) program
Reportable Incident Timeline
Year-by-year reportable incidents (recordable injuries + illnesses + fatalities) submitted by Mws Wire Industries to OSHA's Injury Tracking Application. Each row anchors to OSHA's inspection records search where you can pull the underlying inspection case numbers and citations for that establishment-year.
- 2019: 1 reportable incidents · 0 injuries, 1 illnesses, 0 fatalities - OSHA inspection records (case numbers)
- 2018: 0 reportable incidents · 0 injuries, 0 illnesses, 0 fatalities - OSHA inspection records (case numbers)
Source: OSHA Inspection Information System (IMIS) - inspection case-number records
Year-by-Year Safety Data
| Year | TCR | DART | Injuries | Illnesses | Fatalities |
|---|---|---|---|---|---|
| 2019 | 2.1 | 2.1 | 0 | 1 | 0 |
| 2018 | 0.0 | 0.0 | 0 | 0 | 0 |
What this grade means for you
Use this grade as a relative read on Mws Wire Industries's reported OSHA injury record, strong versus its Magnet wire, insulated, made from purchased copper in wire drawing plants peers, but not a guarantee about any single site today.
- At 31% of the Magnet wire, insulated, made from purchased copper in wire drawing plants benchmark, Mws Wire Industries reports fewer injuries than typical peers, still worth asking how safety is managed day to day. Know your rights
- Judge this record against the wider Magnet wire, insulated, made from purchased copper in wire drawing plants sector, where injury rates vary widely, before comparing it in isolation. See the industry
- Grades reflect 2016–2024 filings; check the latest establishment record straight from OSHA, or look up a different employer. Look up another
Safety grades reflect employers' self-reported OSHA Form 300A filings from 2016 to 2024 and can lag current conditions. A grade is not a guarantee that any specific workplace is safe or unsafe today. See our methodology and disclaimer.
Frequently Asked Questions
What is Mws Wire Industries's safety grade?
How many injuries has Mws Wire Industries reported?
Similar Employers
Matched by safety record across the industry, by workforce size within California, and by nearby establishments in Westlake Village - a different peer set than the category browse links below.
Similar TCR (~1.0)
Similar size (~50 workers)
Read our methodology - how this data is sourced, computed, and verified.
Every figure and grade on PlainSafetyScore is computed directly from OSHA's published Injury Tracking Application data and BLS industry benchmarks, no number is typed in by an editor. See our editorial standards & corrections policy, the methodology behind these safety grades, or report a data error. Data current as of 2016-2024 OSHA ITA release.