Brick veneer, installation · Colorado

Division 60 Denver

Englewood, CO · ~122 workers · 6 years of OSHA Injury Tracking Application data.

C
Average Safety Record
3.3
Avg TCR
2.8
Industry avg
0
Fatalities

The verdict

Division 60 Denver runs at 118% of its industry's injury rate - about level with the typical Brick veneer, installation workplace, earning a grade C.

C
Average Safety Record
3.3
avg TCR · per 100 workers
2.8
industry benchmark (BLS)
20
recordable injuries tracked

Grade compares Division 60 Denver's OSHA Total Case Rate of 3.3 to the Brick veneer, installation BLS benchmark of 2.8 (118% of benchmark) across 6 years of Form 300A filings (2016–2024). <a href="/methodology">See methodology</a> for reporting-limitation caveats.

Injury rate over time

Division 60 Denver's yearly Total Case Rate, against the 2.8 industry benchmark.

1.522.533.544.5 201620172018201920202021 4.22.8 Industry benchmarkDivision 60 Denver TCR
Total Case Rate (recordable injuries per 100 full-time workers), OSHA ITA Form 300A. Industry benchmark: BLS IIF, NAICS 238140.

Where Division 60 Denver falls in its industry

804 Brick veneer, installation establishments

Safer than 50% of graded establishments in this industry, whose median TCR is 3.3.

More dangerous than peersSafer than peers

Narrower to Colorado alone (the establishments it most directly competes with for workers and contracts): ranked #7 safest of 32 Brick veneer, installation employers in Colorado.

Trend analysis for Division 60 Denver

Between 2016 and 2021, Division 60 Denver's Total Case Rate worsened from 2.8 to 4.2 recordable injuries per 100 full-time workers, a 52% increase across 5 years of OSHA reporting.

The safest year on record was 2019, at a TCR of 2.1, while 2017 saw the highest rate, at 4.3, a spread of 2.2 points between the best and worst reporting years. That's a wide swing relative to the establishment's overall rate, worth checking the year-by-year table below for whether a single severe year is driving the average, rather than a sustained trend.

Summed across those 6 reporting years, Division 60 Denver recorded 20 total injuries and illnesses, with no fatalities reported in any of those years. Readers comparing establishments should weigh the 6-year trend above alongside establishment size, since a larger workforce naturally accumulates more raw incidents even at a lower per-100-worker rate.

Verify This Employer with OSHA

The 20 injuries, 2 illnesses shown on this page for Division 60 Denver are sourced from its own 6 years of mandatory OSHA Form 300A summaries. Cross-check the underlying establishment record directly against the federal source, name, NAICS classification, recordable case totals, and inspection history are all searchable on OSHA's Establishment-Specific Injury and Illness Data system.

Verify on OSHA Establishment Search

Source: U.S. Department of Labor, OSHA Establishment-Specific Injury and Illness Data. NAICS 238140 - Brick veneer, installation.

DART Rate, Transparent Calculation (2021)

What is the DART rate formula?

DART (Days Away, Restricted, or Transferred) is computed by OSHA as incidents × 200,000 ÷ hours worked. The 200,000-hour denominator equals roughly 100 full-time workers, which lets establishments of very different sizes be compared directly.

3 DART incidents × 200,000 ÷ 142,018 hours worked = 4.22 DART

Methodology: 29 CFR 1904, OSHA Form 300A recordkeeping

Cross-Validating Context, Establishment vs Industry vs State

Benchmark TCR Source
Division 60 Denver (this establishment) 3.29 OSHA ITA Form 300A, 6-year avg
Masonry contractors industry avg 2.80 BLS IIF, NAICS 238140
Colorado state avg (all industries) 5.41 OSHA ITA, state-level rollup

Industry benchmarks: Bureau of Labor Statistics, Injuries, Illnesses, and Fatalities (IIF) program

Reportable Incident Timeline

Year-by-year reportable incidents (recordable injuries + illnesses + fatalities) submitted by Division 60 Denver to OSHA's Injury Tracking Application. Each row anchors to OSHA's inspection records search where you can pull the underlying inspection case numbers and citations for that establishment-year.

Source: OSHA Inspection Information System (IMIS) - inspection case-number records

Year-by-Year Safety Data

Year TCR DART Injuries Illnesses Fatalities
2021 4.2 4.2 1 2 0
2020 2.3 1.5 3 0 0
2019 2.1 1.0 2 0 0
2018 4.1 3.3 5 0 0
2017 4.3 2.1 6 0 0
2016 2.8 0.9 3 0 0

What this grade means for you

Use this grade as a relative read on Division 60 Denver's reported OSHA injury record versus its Brick veneer, installation peers, not a verdict on whether any single site is safe today.

  • At 118% of the Brick veneer, installation benchmark, Division 60 Denver reports more injuries than typical peers, ask specifically how the employer is reducing them. Know your rights
  • Judge this record against the wider Brick veneer, installation sector, where injury rates vary widely, before comparing it in isolation. See the industry
  • Grades reflect 2016–2024 filings; check the latest establishment record straight from OSHA, or look up a different employer. Look up another

Safety grades reflect employers' self-reported OSHA Form 300A filings from 2016 to 2024 and can lag current conditions. A grade is not a guarantee that any specific workplace is safe or unsafe today. See our methodology and disclaimer.

Frequently Asked Questions

What is Division 60 Denver's safety grade?
Division 60 Denver has a safety grade of C (Average Safety Record). This grade is based on their average Total Case Rate (TCR) of 3.3 compared to the BLS industry benchmark of 2.8 for Brick veneer, installation.
How many injuries has Division 60 Denver reported?
Division 60 Denver has reported 20 total injuries and 0 fatalities across 6 years of OSHA data (2021, 2020, 2019, 2018, 2017, 2016). This data comes from mandatory OSHA Injury Tracking Application (ITA) reports.

Similar Employers

Matched by safety record across the industry, by workforce size within Colorado, and by nearby establishments in Englewood - a different peer set than the category browse links below.

Similar TCR (~3.3)

Similar size (~122 workers)

Nearby in Englewood

Data Source: OSHA Injury Tracking Application (ITA), mandatory establishment-level injury/illness reports. Grades compare employer Total Case Rate (TCR) to BLS IIF industry benchmarks. Data covers years reported by this establishment: 2021, 2020, 2019, 2018, 2017, 2016. This is publicly available government data - not a legal determination of workplace conditions.

Read our methodology - how this data is sourced, computed, and verified.

Data sourced from official public datasets. See our methodology for details. Retrieved and formatted by PlainSafetyScore Editorial

Every figure and grade on PlainSafetyScore is computed directly from OSHA's published Injury Tracking Application data and BLS industry benchmarks, no number is typed in by an editor. See our editorial standards & corrections policy, the methodology behind these safety grades, or report a data error. Data current as of 2016-2024 OSHA ITA release.