Flag and banner shops · Utah

Colonial Flag

Sandy, UT · ~35 workers · 2 years of OSHA Injury Tracking Application data.

F
Failing Safety Record
9.2
Avg TCR
3.4
Industry avg
0
Fatalities

The verdict

Colonial Flag runs at 271% of its industry's injury rate - far more dangerous than the typical Flag and banner shops workplace, earning a grade F.

F
Failing Safety Record
9.2
avg TCR · per 100 workers
3.4
industry benchmark (BLS)
6
recordable injuries tracked

Grade compares Colonial Flag's OSHA Total Case Rate of 9.2 to the Flag and banner shops BLS benchmark of 3.4 (271% of benchmark) across 2 years of Form 300A filings (2016–2024). <a href="/methodology">See methodology</a> for reporting-limitation caveats.

Injury rate over time

Colonial Flag's yearly Total Case Rate, against the 3.4 industry benchmark.

2468101214 20202021 12.33.4 Industry benchmarkColonial Flag TCR
Total Case Rate (recordable injuries per 100 full-time workers), OSHA ITA Form 300A. Industry benchmark: BLS IIF, NAICS 453998.

Where Colonial Flag falls in its industry

83 Flag and banner shops establishments

Safer than 25% of graded establishments in this industry, whose median TCR is 3.5.

More dangerous than peersSafer than peers

Trend analysis for Colonial Flag

Between 2020 and 2021, Colonial Flag's Total Case Rate worsened from 6.2 to 12.3 recordable injuries per 100 full-time workers, a 100% increase across 1 year of OSHA reporting.

The safest year on record was 2020, at a TCR of 6.2, while 2021 saw the highest rate, at 12.3, a spread of 6.2 points between the best and worst reporting years. That's a wide swing relative to the establishment's overall rate, worth checking the year-by-year table below for whether a single severe year is driving the average, rather than a sustained trend.

Summed across those 2 reporting years, Colonial Flag recorded 6 total injuries and illnesses, with no fatalities reported in any of those years. Readers comparing establishments should weigh the 2-year trend above alongside establishment size, since a larger workforce naturally accumulates more raw incidents even at a lower per-100-worker rate.

Verify This Employer with OSHA

The 6 injuries shown on this page for Colonial Flag are sourced from its own 2 years of mandatory OSHA Form 300A summaries. Cross-check the underlying establishment record directly against the federal source, name, NAICS classification, recordable case totals, and inspection history are all searchable on OSHA's Establishment-Specific Injury and Illness Data system.

Verify on OSHA Establishment Search

Source: U.S. Department of Labor, OSHA Establishment-Specific Injury and Illness Data. NAICS 453998 - Flag and banner shops.

DART Rate, Transparent Calculation (2021)

What is the DART rate formula?

DART (Days Away, Restricted, or Transferred) is computed by OSHA as incidents × 200,000 ÷ hours worked. The 200,000-hour denominator equals roughly 100 full-time workers, which lets establishments of very different sizes be compared directly.

1 DART incidents × 200,000 ÷ 65,008 hours worked = 3.08 DART

Methodology: 29 CFR 1904, OSHA Form 300A recordkeeping

Cross-Validating Context, Establishment vs Industry vs State

Benchmark TCR Source
Colonial Flag (this establishment) 9.23 OSHA ITA Form 300A, 2-year avg
Miscellaneous Retail Stores - NEC industry avg 3.40 BLS IIF, NAICS 453998
Utah state avg (all industries) 4.77 OSHA ITA, state-level rollup

Industry benchmarks: Bureau of Labor Statistics, Injuries, Illnesses, and Fatalities (IIF) program

Reportable Incident Timeline

Year-by-year reportable incidents (recordable injuries + illnesses + fatalities) submitted by Colonial Flag to OSHA's Injury Tracking Application. Each row anchors to OSHA's inspection records search where you can pull the underlying inspection case numbers and citations for that establishment-year.

Source: OSHA Inspection Information System (IMIS) - inspection case-number records

Year-by-Year Safety Data

Year TCR DART Injuries Illnesses Fatalities
2021 12.3 3.1 4 0 0
2020 6.2 3.1 2 0 0

What this grade means for you

Use this grade as a relative read on Colonial Flag's reported OSHA injury record versus its Flag and banner shops peers, not a verdict on whether any single site is safe today.

  • At 271% of the Flag and banner shops benchmark, Colonial Flag reports more injuries than typical peers, ask specifically how the employer is reducing them. Know your rights
  • Judge this record against the wider Flag and banner shops sector, where injury rates vary widely, before comparing it in isolation. See the industry
  • Grades reflect 2016–2024 filings; check the latest establishment record straight from OSHA, or look up a different employer. Look up another

Safety grades reflect employers' self-reported OSHA Form 300A filings from 2016 to 2024 and can lag current conditions. A grade is not a guarantee that any specific workplace is safe or unsafe today. See our methodology and disclaimer.

Frequently Asked Questions

What is Colonial Flag's safety grade?
Colonial Flag has a safety grade of F (Failing Safety Record). This grade is based on their average Total Case Rate (TCR) of 9.2 compared to the BLS industry benchmark of 3.4 for Flag and banner shops.
How many injuries has Colonial Flag reported?
Colonial Flag has reported 6 total injuries and 0 fatalities across 2 years of OSHA data (2021, 2020). This data comes from mandatory OSHA Injury Tracking Application (ITA) reports.

Similar Employers

Matched by safety record across the industry, by workforce size within Utah, and by nearby establishments in Sandy - a different peer set than the category browse links below.

Data Source: OSHA Injury Tracking Application (ITA), mandatory establishment-level injury/illness reports. Grades compare employer Total Case Rate (TCR) to BLS IIF industry benchmarks. Data covers years reported by this establishment: 2021, 2020. This is publicly available government data - not a legal determination of workplace conditions.
Data sourced from official public datasets. See our methodology for details. Retrieved and formatted by PlainSafetyScore Editorial

Every figure and grade on PlainSafetyScore is computed directly from OSHA's published Injury Tracking Application data and BLS industry benchmarks, no number is typed in by an editor. See our editorial standards & corrections policy, the methodology behind these safety grades, or report a data error. Data current as of 2016-2024 OSHA ITA release.