Stephens Pipe and Steel Mount Sterling, OH
Open-data reference.
MT. STERLING, OH | Chain link fencing, iron or steel, made in wire drawing plants
~129 avg employees | 7 years of OSHA data
Stephens Pipe and Steel Mount Sterling, OH has an average TCR of 3.9, which is 117% of the industry average (3.3) for Chain link fencing, iron or steel, made in wire drawing plants. This is worse than average.
Safety Insights for Stephens Pipe and Steel Mount Sterling, OH
Stephens Pipe and Steel Mount Sterling, OH operates an establishment with approximately 129 full-time equivalent workers in MT. STERLING, OH, classified under the Chain link fencing, iron or steel, made in wire drawing plants industry (NAICS 331222). Across 7 years of mandatory OSHA Injury Tracking Application (ITA) reporting, this employer has accumulated 26 recordable injuries, 13 occupational illnesses, and 0 workplace fatalities. The average Total Case Rate (TCR) of 3.9 injuries per 100 full-time workers per year provides the anchor metric for the C letter grade (Average Safety Record).
Benchmarked against the Bureau of Labor Statistics industry average of 3.3 for Chain link fencing, iron or steel, made in wire drawing plants, Stephens Pipe and Steel Mount Sterling, OH's workforce experiences 117% of the typical injury burden. This ratio matters because TCR already normalizes for hours worked — a 200,000-hour exposure base equals roughly 100 full-time workers — so establishments with very different headcounts can be compared directly. A TCR above the benchmark flags a higher-than-typical risk profile for jobseekers, insurers, and enforcement agencies to examine.
Multi-year trend analysis is the single most reliable signal here: a one-year spike could reflect a single severe event, whereas sustained elevation across 7 reporting cycles points to systemic hazard exposure. Readers evaluating Stephens Pipe and Steel Mount Sterling, OH as an employer, contractor, investment, or regulatory target should examine the yearly DART rate (days away, restricted, or transferred), the fatality count of 0, and any year-over-year deterioration shown in the table below. All figures come directly from employer-submitted OSHA Form 300A summaries — there is no modeling, estimation, or third-party adjustment layered on top of the government data.
Verify This Employer with OSHA
All injury, illness, and fatality figures on this page are sourced from Stephens Pipe and Steel Mount Sterling, OH's own mandatory OSHA Form 300A summaries. Cross-check the underlying establishment record directly against the federal source — name, NAICS classification, recordable case totals, and inspection history are all searchable on OSHA's Establishment-Specific Injury and Illness Data system.
Verify on OSHA Establishment SearchSource: U.S. Department of Labor — OSHA Establishment-Specific Injury and Illness Data. NAICS 331222 — Chain link fencing, iron or steel, made in wire drawing plants.
DART Rate — Transparent Calculation (2024)
DART (Days Away, Restricted, or Transferred) is computed by OSHA as incidents × 200,000 ÷ hours worked. The 200,000-hour denominator equals roughly 100 full-time workers, which lets establishments of very different sizes be compared directly.
3 DART incidents × 200,000 ÷ 237,592 hours worked = 2.53 DART
Methodology: 29 CFR 1904 — OSHA Form 300A recordkeeping
Cross-Validating Context — Establishment vs Industry vs State
| Benchmark | TCR | Source |
|---|---|---|
| Stephens Pipe and Steel Mount Sterling, OH (this establishment) | 3.86 | OSHA ITA Form 300A, 7-year avg |
| Drawing iron or steel wire from purchased iron or steel and fabricating wire products industry avg | 3.30 | BLS IIF, NAICS 331222 |
| Ohio state avg (all industries) | 31.77 | OSHA ITA, state-level rollup |
Industry benchmarks: Bureau of Labor Statistics — Injuries, Illnesses, and Fatalities (IIF) program
Reportable Incident Timeline
Year-by-year reportable incidents (recordable injuries + illnesses + fatalities) submitted by Stephens Pipe and Steel Mount Sterling, OH to OSHA's Injury Tracking Application. Each row anchors to OSHA's inspection records search where you can pull the underlying inspection case numbers and citations for that establishment-year.
- 2024: 7 reportable incidents · 4 injuries, 3 illnesses, 0 fatalities — OSHA inspection records (case numbers)
- 2023: 7 reportable incidents · 5 injuries, 2 illnesses, 0 fatalities — OSHA inspection records (case numbers)
- 2022: 5 reportable incidents · 2 injuries, 3 illnesses, 0 fatalities — OSHA inspection records (case numbers)
- 2021: 4 reportable incidents · 3 injuries, 1 illnesses, 0 fatalities — OSHA inspection records (case numbers)
- 2020: 4 reportable incidents · 4 injuries, 0 illnesses, 0 fatalities — OSHA inspection records (case numbers)
- 2019: 6 reportable incidents · 6 injuries, 0 illnesses, 0 fatalities — OSHA inspection records (case numbers)
- 2018: 6 reportable incidents · 2 injuries, 4 illnesses, 0 fatalities — OSHA inspection records (case numbers)
Source: OSHA Inspection Information System (IMIS) — inspection case-number records
Year-by-Year Safety Data
| Year | TCR | DART | Injuries | Illnesses | Fatalities |
|---|---|---|---|---|---|
| 2024 | 5.9 | 2.5 | 4 | 3 | 0 |
| 2023 | 4.4 | 3.1 | 5 | 2 | 0 |
| 2022 | 3.1 | 1.2 | 2 | 3 | 0 |
| 2021 | 2.6 | 1.9 | 3 | 1 | 0 |
| 2020 | 2.7 | 2.7 | 4 | 0 | 0 |
| 2019 | 4.1 | 3.5 | 6 | 0 | 0 |
| 2018 | 4.2 | 1.4 | 2 | 4 | 0 |
Frequently Asked Questions
What is Stephens Pipe and Steel Mount Sterling, OH's safety grade?
How is the safety grade calculated?
How many injuries has Stephens Pipe and Steel Mount Sterling, OH reported?
Where does PlainSafetyScore get its data?
Explore More Safety Data
Read our methodology — how this data is sourced, computed, and verified.